I've got some stuff here that I'd like to offer, some of them are parts that I made a while ago, some are prototypes:

Raw Stubby Freak barrel tip $10, raw Tarantula lowrise $8 (a few hi-rise ones available), raw trigger blanks (need pivot pin holes drilled to 3/16", pre-/post-travel set screw holes and switch activation holes) $0.50 ea (10 pcs for $4). I can machine all holes for $5 each trigger.
 


Titanium bolt pin (long or short) $8.



Raw Grippie (rear carry grip) for OTB frame, stock frame Impulse, and old school Shocker $8. Raw Predator Impulse front cap $8.



Pics of the raw Impluse bodies. Some are finished stock milling, and some are totally unmilled on the outside, but fully functional (all functional machining is done).




Raw stubby tip for J+J barrel $15. There are 2 styles, and I only have 2 of each!



Here are some pics of a couple of Imps I milled. The dust black is one I did for a customer that didn't come out well enough in anodizing, so I ended up doing another one for him. Functionally it's fine, doesn't include solenoid or Vision cover. The other is of the very 1st Predator Impulse that was milled. It was the test mule if you will. It still has the original anodizing on the internals and ends.





I also have 4 black delrin stock hole pattern bolts, 2 white/1 black delrin Undertow Impulse bolts. $12

Pm sent

Bear with me guys, I'm finally getting around to replies with holiday stuff still lingering! Thanks.

I used to anodize in house, but it was so time consuming I no longer offer it. Sorry. If you want one, I'll polish it for you, and you can use it like that until you can find someone who's getting a batch done, and toss it in for a little bit of cash.

Or I could spray paint it for you!

Thanks.

Yeah, it is nice to be back into it. It's been a long hiatus, though I wasn't totally out of it. I was just taking on the occasional work here and there. Got burned out before. Thanks for the support.

Rock on, brother.

Do you want the prototype Pred body pictured above? I won't be ready to take new milling for a little bit. But as soon as I can, I'd be more than happy to mill one for you.

Yes, if you mean the yellow one on my website on the picsncrap page, then yes it's the same version. Some of the scallops are going to have to be smoothed out by hand with around 600 grit sandpaper, then polished. I'm not sure when I'll be ready to mill more of them, it may be a while. It's up to you really.