I will definitly get some

I am looking for a ndz he ram assembly including the slik shot, hammer, and preferably back cap. I am also looking for a rip valve. I am also looking for the ndz  pull-pin.

I was wondering how much material you can remove from it before you have bolt sealing issues. I think I am going to attempt to do this myself since you can find stock replacement bodies for $20-$30 rather than a couple hundred on a good metal working place. Thanks in advance for any help you can provide.

So you are saying to use only the front pivot pin. When I bought my impulse used it had two pins and both were the same size. I have tested it and I think it feels best with only the back pivot pin bought the pull was shorter with both so I figured that was the purpose of it.

The trigger pins for my impulse are lost so I was wondering what the diameter on them is. I am going to go down to hardware store and see what alternatives I have to paying 16 bucks plus shipping for two trigger pins with c-clips.